Год издания: 1999
Страниц: 369
Язык: английский
Формат: PDF
Размер: 75 Мб
Страниц: 369
Язык: английский
Формат: PDF
Размер: 75 Мб
2409201522_38
Руководство по устройству, эксплуатации, техническому обслуживанию и ремонту автомобилей Citroen Xantia 1993-2001 гг. производства, оборудованных бензиновыми 4-цилиндровыми двигателями рабочим объёмом 1.6, 1.8, 2.0 литра и дизельными двигателями рабочим объёмом 1.9, 2.0 ми 2.1 литра.
Руководство по устройству, эксплуатации, техническому обслуживанию и ремонту автомобилей Citroen Xantia 1993-2001 гг. производства, оборудованных бензиновыми 4-цилиндровыми двигателями рабочим объёмом 1.6, 1.8, 2.0 литра и дизельными двигателями рабочим объёмом 1.9, 2.0 ми 2.1 литра.
Отрывок из книги:
Removal
1 Chock the rear wheels and place the selector lever in the "N" (neutral) position. Jack up the front of the vehicle, and securely support it on axle stands (see "Jacking and vehicle support"). Remove both front roadwheels.
2 On the 4 HP 14 transmission, drain the transmission fluid as described in Chapter 1A or 1B, then refit the drain plugs, tightening them securely. Draining the AL4 transmission is not necessary, unless internal repairs are to be carried out.
3 Open the pressure regulator release screw and set the height control to the "LOW" setting.
4 Remove the air cleaner housing and/or inlet duct as described in Chapter 4.
5 Remove the hydraulic fluid reservoir as described in Chapter 9.
6 Remove the battery, battery tray and mounting plate as described in Chapter 5A
7 Remove the starter motor as described in Chapter 5A.
8 As applicable, remove the components from the left-hand end of the cylinder head including the vacuum reservoir and idle control valve.
9 Where necessary, unscrew the mounting nuts and move the ABS hydraulic control block to one side. Remove the ABS bracket.
1 Chock the rear wheels and place the selector lever in the "N" (neutral) position. Jack up the front of the vehicle, and securely support it on axle stands (see "Jacking and vehicle support"). Remove both front roadwheels.
2 On the 4 HP 14 transmission, drain the transmission fluid as described in Chapter 1A or 1B, then refit the drain plugs, tightening them securely. Draining the AL4 transmission is not necessary, unless internal repairs are to be carried out.
3 Open the pressure regulator release screw and set the height control to the "LOW" setting.
4 Remove the air cleaner housing and/or inlet duct as described in Chapter 4.
5 Remove the hydraulic fluid reservoir as described in Chapter 9.
6 Remove the battery, battery tray and mounting plate as described in Chapter 5A
7 Remove the starter motor as described in Chapter 5A.
8 As applicable, remove the components from the left-hand end of the cylinder head including the vacuum reservoir and idle control valve.
9 Where necessary, unscrew the mounting nuts and move the ABS hydraulic control block to one side. Remove the ABS bracket.
